Solar Sun Rings

The Solar Sun Ring is a passive solar swimming pool heating device made from two sheets of heavyweight U.V. resistant vinyl. The upper clear layer holds insulating air and focuses sunlight on the blue colored lower layer.

The blue layer absorbs about 50% of the sunlight and converts it to heat. The balance of the sunlight is allowed to pass through for deep water heating.

How Do Solar Sun Rings Work?

At night the contained air acts as an insulating blanket to retain heat gained during daylight. Solar Sun Rings are equipped with six magnets to improve clarity and decrease hardness of the water in your pool. The magnets are positioned to facilitate rafting. The strength of the magnets will permit single position removal but will easily separate to prevent entrapment in accidental falls.

Solar Sun Rings were designed to be compatible with automatic pool cleaners. In the event the suction hose catches on a ring, the ring will separate from the raft to allow the pool cleaner to continue.

Neither water nor pool chemicals can evaporate through the Solar Sun Rings two layers of heavyweight vinyl. You will save water and chemicals about equal to the percentage of the surface covered. Once the water in your pool has reached adequate temperature, Solar Sun Rings may be turned over to conserve water by limiting evaporation without significantly heating the water.

Solar Sun Rings Help Your Pool Stay Clean

Your pool requires some direct sunlight and open water to stay healthy. The open water around the raft of Solar Sun Rings and the triangle caused by the convergence of three Solar Sun Rings is by design. These open areas allow your pool to receive some direct sunlight. This sunlight will greatly reduce the incidence of mustard algae.

Are Solar Sun Rings Compatible With My Pool?

Solar Sun Rings may be used on all chlorine or salt water system pools, whether in ground or above ground.

How Do I Clean My Solar Sun Rings?

After removal from the swimming pool Solar Sun Rings can be easily cleaned with a sponge and white vinegar solution.

How Many Solar Sun Rings Do I Need?
We recommend enough Solar Sun Rings be purchased to cover 70% to 80% of your pools surface, ignoring the small triangles between the rings. Calculate 1 Solar Sun Ring for every 33 square feet of surface area.

12' Round: 3 Solar Sun Rings
15' Round: 5 Solar Sun Rings
16' Round: 5 Solar Sun Rings
18' Round: 7 Solar Sun Rings
21' Round: 10 Solar Sun Rings
24' Round: 12 Solar Sun Rings
27' Round: 15 Solar Sun Rings
28' Round: 16 Solar Sun Rings
30' Round: 18 Solar Sun Rings
33' Round: 22 Solar Sun Rings

12'x18' Oval: 4 Solar Sun Rings
12'x24' Oval: 6 Solar Sun Rings
15'x24' Oval: 7 Solar Sun Rings
15'x26' Oval: 8 Solar Sun Rings
15'x30' Oval: 9 Solar Sun Rings
16'x32' Oval: 10 Solar Sun Rings
18'x33' Oval: 12 Solar Sun Rings
18'x40' Oval: 14 Solar Sun Rings

---

INSTRUCTIONS FOR USE
PROPER INFLATION IS NECESSARY TO USE THIS PRODUCT INFLATION

INFLATION

Inner Grid:Proper Inflation
The inner grid should be inflated orally with about two large breaths of air for an average person. Do not use more air, two breaths is all that is needed. Close the valve. Bunch up the SSR and move the contained air around to separate both layers of plastic. The SSR cannot be made to lie flat unless the layers are separated. The SSR should be about the size of a soccer ball when bunched up.

Outer Ring:Over Inflation
Inflate the outer ring orally until it is firm. Close the valve. Place each SSR single layer in direct sunlight on a flat non-abrasive surface until the packing lines relax. This should take from 30 minutes to 3 hours depending on the intensity of the sun. If the SSR does not lie flat after the packing lines are relaxed, examine the SSR for areas not separated. If the SSR still does not lie flat measure the diameter. A properly inflated SSR is 59 inches or 149.86cm Distorted Inflationin diameter. If the SSR is smaller use the deflation tube provided to let air out of the inner grid until it lies flat. Excessive air in the grid section, deep packing lines and failure to separate both layers of plastic will all cause the outer edge to curl and distort.
HOW TO USE THE SOLAR SUN RINGS
HEATING: Once the Solar Sun Rings are inflated, cover up to 60% to 70% of the surface of your pool with Solar Sun Rings by placing the blue colored side on the water. You should not cover more than 70% of the surface on deep pools and not more than 80% on shallow pools. For the best solar effect, keep the upper surface of the Solar Sun Rings clean and clear.
COOLING: Turn the Solar Sun Rings over so the blue side is up. The Solar Sun Rings do not heat water efficiently when upside down.
WATER AND CHEMICAL SAVING: Neither water nor chemicals can evaporate through the two layers of heavyweight vinyl. You will save on water and chemicals about equal to the actual percentage of water covered.

CARE OF SOLAR SUN RINGS
CARE: Once inflated proper care of this product will greatly extend its useful life. Pool decking is designed to be abrasive to prevent slips and falls. Do not walk on Solar Sun Rings or drag Solar Sun Rings on this abrasive surface. When Solar Sun Rings are not on the pool water do not stack them in direct sunlight, excessive internal temperatures will develop and melt the vinyl films.
Solar Sun Rings are passive pool heating devices and should not be used as pool toys.

WARRANTY
WARRANTY: Solar Sun Rings are warranted to be free of manufacturing defects for two years. Warranty is limited to materials and workmanship. Solar Sun Rings will not warranty products for damage or suitability.